Chevrolet Blazer key fob battery

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Snap the halves back together, slide the metal key home, and press each button, then try the start button from the driver's seat.

On many recent GM smart remotes a button on the side releases the key; the slot at the bottom is where the case opens.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Separate remote fob

1. This remote is its own fob, separate from the metal key, which makes it one of the easier ones to open.
2. Look for a screw on the back or a notch on the edge. Remove the screw if present, then twist a coin in the notch to split the case.
3. Replace the cell, keeping the + side where it was, and check the small metal tab still touches it.
4. Close the fob and test it. If it does not work, open it again and check the cell is seated flat.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.