carfobbattery

Honda Insight key fob battery

13 of the 16 model years listed for the Honda Insight have a proven battery. The most common answer is CR1616. Rows below run oldest to newest; a year can appear twice when the car came with more than one kind of key.

  1. 2000-2006Remote (separate)

    CR2025

    FCC ID A269ZUA101

    Two sites agree: uhs-hardware.com and bestkeysupply.com (checked Nov 2, 2026)

    Find CR2025 on Amazon
  2. 2010-2013Key-head remote

    CR1616

    FCC ID MLBHLIK-1T

    Two sites agree: americankeysupply.com and uhs-hardware.com (checked Nov 2, 2026)

    Find CR1616 on Amazon
  3. 2014Key-head remote

    CR1616

    Two sites agree: uhs-hardware.com and locksmithkeyless.com (checked Nov 2, 2026)

    Find CR1616 on Amazon
  4. 2019Smart key

    CR2032

    Owner's manual: manua.ls (checked Nov 1, 2026)

    Manual text: “Battery type: CR2032”

    Find CR2032 on Amazon
  5. 2020-2022Smart key

    Not confirmed yet

Changing the battery

Separate remote fob

  1. This remote is its own fob, separate from the metal key, which makes it one of the easier ones to open.
  2. Turn it over: some older fobs use one small screw, newer ones just clip. Pry at the seam once any screw is out.
  3. Lift the old coin cell out and press the new one in with matching orientation.
  4. Reassemble and test from a short distance.

A CR2025 is 20 mm across and 2.5 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Key with remote in the head

  1. This type has the buttons built into the key head. The cell is inside that head, between two clipped halves.
  2. Work a thin flat tool into the seam near the blade and twist; go round slowly if it does not open at once.
  3. Inside you may find a small circuit board in a tray. Lift the board out if the cell is underneath, swap the cell with the same side up, and refit the board.
  4. Close the head, check there is no gap, and try the buttons.

A CR1616 is 16 mm across and 1.6 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

Smart key (push-button start)

  1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
  2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
  3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
  4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Honda smart keys typically have a release lever for the built-in key. Twist a coin or the key tip in the slot it exposes to split the case.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Coin cells are a choking and burn hazard for children. Store the spares in their original pack, out of reach.

Other Honda models