Lexus ES key fob battery

Key with remote in the head

1. Here the key blade and remote are one piece. You open the plastic head, not the blade.
2. Work a thin flat tool into the seam near the blade and twist; go round slowly if it does not open at once.
3. The coin cell is usually under or on the back of a small board. Keep the rubber button pad in place while you swap the cell.
4. Close the head, check there is no gap, and try the buttons.

A CR1616 is 16 mm across and 1.6 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

A CR2016 is 20 mm across and 1.6 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

Lexus smart keys usually hide the metal key behind a release button; the cover opens from the notch next to where the key sat.

A CR1632 is 16 mm across and 3.2 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.