Subaru BRZ key fob battery

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Note which side of the old coin cell faces up (usually the side with the writing), lift it out with a plastic tool, and press the new one in the same way.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Subaru access keys usually hide an emergency key; with it out, the cover opens at the slot.

A CR1632 is 16 mm across and 3.2 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

A CR2016 is 20 mm across and 1.6 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Key with remote in the head

1. The remote electronics sit in the plastic head of the key itself, so there is no separate fob to open.
2. Many key heads split along the side seam. Start at the small notch and pry a little at a time.
3. Replace the cell with the same face showing, and make sure the rubber keypad sits flat before closing.
4. Snap it closed and press each button. The car still starts with a dead remote battery on most of these keys, because the start chip needs no battery.

A CR2016 is 20 mm across and 1.6 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.