Toyota Sequoia key fob battery

Separate remote fob

1. A separate fob has no key blade inside, so it opens with nothing but a coin or a small screwdriver.
2. Look for a screw on the back or a notch on the edge. Remove the screw if present, then twist a coin in the notch to split the case.
3. Replace the cell, keeping the + side where it was, and check the small metal tab still touches it.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2016 is 20 mm across and 1.6 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. The gap left by the metal key usually has a pry point. A slow twist with a thin flat tool (tape on the tip saves the plastic) opens the two halves.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

On most Toyota smart keys the metal key slides out after you press a small release, and the case opens at the slot it leaves behind.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.