Toyota Tacoma key fob battery

Separate remote fob

1. The remote is a small standalone unit. You will not need to touch the ignition key at all.
2. Look for a screw on the back or a notch on the edge. Remove the screw if present, then twist a coin in the notch to split the case.
3. Swap the cell or cells, keeping the same side up as the old ones.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Key with remote in the head

1. The remote electronics sit in the plastic head of the key itself, so there is no separate fob to open.
2. Many key heads split along the side seam. Start at the small notch and pry a little at a time.
3. The coin cell is usually under or on the back of a small board. Keep the rubber button pad in place while you swap the cell.
4. Close the head, check there is no gap, and try the buttons.

A CR2016 is 20 mm across and 1.6 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Start by freeing the hidden metal key: there is a latch or slide on the case, and the blade comes out once it moves.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

On most Toyota smart keys the metal key slides out after you press a small release, and the case opens at the slot it leaves behind.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.