Ford F-650/F-750 key fob battery

Key with remote in the head

1. This type has the buttons built into the key head. The cell is inside that head, between two clipped halves.
2. Many key heads split along the side seam. Start at the small notch and pry a little at a time.
3. The coin cell is usually under or on the back of a small board. Keep the rubber button pad in place while you swap the cell.
4. Snap it closed and press each button. The car still starts with a dead remote battery on most of these keys, because the start chip needs no battery.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Look along the edge for a notch. A coin turned in that notch usually separates the remote half from the blade half.
3. Lift the cell out with a plastic tool and press in the new one with the + side matching.
4. Close it up, check the blade still flips cleanly, and test the buttons at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Use the slot where the metal key sat. Twist, do not lever hard, and work along the seam until the halves separate.
3. Note which side of the old coin cell faces up (usually the side with the writing), lift it out with a plastic tool, and press the new one in the same way.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

Ford intelligent access fobs usually have a release for the emergency key. The key blade itself fits the pry slot.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.