Ford GT key fob battery

Separate remote fob

1. This remote is its own fob, separate from the metal key, which makes it one of the easier ones to open.
2. Turn it over: some older fobs use one small screw, newer ones just clip. Pry at the seam once any screw is out.
3. Swap the cell or cells, keeping the same side up as the old ones.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Start by freeing the hidden metal key: there is a latch or slide on the case, and the blade comes out once it moves.
2. The gap left by the metal key usually has a pry point. A slow twist with a thin flat tool (tape on the tip saves the plastic) opens the two halves.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Ford intelligent access fobs usually have a release for the emergency key. The key blade itself fits the pry slot.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.