Kia Niro key fob battery

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Find the seam or small slot on the body (often at the end away from the blade) and twist a coin or small flat screwdriver in it until the cover lifts.
3. Lift the cell out with a plastic tool and press in the new one with the + side matching.
4. Clip the body closed, fold the blade, and test the buttons from a few steps away.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Note which side of the old coin cell faces up (usually the side with the writing), lift it out with a plastic tool, and press the new one in the same way.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Kia smart keys usually free the mechanical key with a button, and the case opens at the gap it leaves.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.